WES Lexmark - Prerequisites and prior configuration
Prerequisites
-
Lexmark WES v2 is compatible with devices supporting eSF SDK v3.
-
Lexmark WES v3 is compatible with devices supporting eSF SDK v4.X, 5.X or 6.X.
-
The Lexmark device must be ready to accept embedded applications.
-
To enable secure printing, models equipped with SDK 4.X must have a Lexmark-supplied eSF license installed on the devices.
-
Printing devices with screens smaller than 4.3 inches are not supported.
Configure ports
The network ports to open are the following:
| Brand | Source | Target | Port | Protocole |
|---|---|---|---|---|
| Lexmark SDK4* | WES | Service Watchdoc (kernel) | TCP 5754
TCP 5753 |
HTTP HTTPS |
| Lexmark SDK6+ |
WES | Service Watchdoc (kernel) | TCP 5753 | HTTPS |
|
Lexmark |
Service Watchdoc | Périphérique d'impression | TCP 80 TCP 443 |
HTTP HTTPS |
* SSL only is not possible with the SDK4.
In the event of a multi-server configuration (load balancing) for devices equipped with different SDKs, it is therefore necessary to open:
-
the port 5754
-
the port 5753 .
Prior configuration
Consult the compatibility list to check that your device is compatible with the WES.
The configuration of the Lexmark device is carried out automatically during the installation of the WES. No manual intervention is required.