Toshiba WES - Install the WES onto the queue

Access the interface

  1. From the Main Menu of the Watchdoc administration interface, in the Production section, click Print Queues, Queue Groups & Pools:

     



→ You will access the print queues interface.

  1. In this list, activate the Controlled filter:

 

  1. Click on the name of the queue on which you want to install the WES.

    → You access the Queue management interface.

Configure the Validation mode

  • In the queue management interface, click on Edit properties button.

  • In the General information section> Mode subsection, select the Validation mode;

  • Save the queue configuration.

    • Install the WES

    1. Go back to the queue management interface, then click on Properties tab:


    This section contains several buttons:

    • MFP web interface: shortcut to the device's internal administration website.It can take up to 30 seconds;

    • Enable logs: allows you to enable WES logs (WES traces);

    • Disable logs: allows you to disable WES logs (WES traces);

    • Install…: Enables Watchdoc to install the embedded interface (WES) on the device.

    • Uninstall: Enables Watchdoc to uninstall the embedded interface (WES) on the device;

    • Edit the settings: gives access to the WES profile configuration interface.

    1. In the Toshiba Open Platform section, clicl on the Install button to finish installing the application:

      There are several stages in the installation process, which are listed in the Installation Report:

       

    2. Try to print to check the WES installation.